VaCooL
Posts: 18
Registered: 20-6-2003
Member Is Offline
Mood: Porsche 911 GT1 '96
|
|
posted on 10-5-2005 at 17:39
|
|
|
Porsche 911 GT3 RSR
I have a Tamiya 911 GT3 kit and i have build the Scaleproduction RSR kit on it, so here is my problem :
Which class is the car allowed in?
Because its 84mm wide over the rear with the kit on it.
Regards Jan
|
|
|
|
tamar
Posts: 804
Registered: 5-1-1989
Location: Gouda
Member Is Offline
Mood: A new beginning 
|
|
posted on 10-5-2005 at 20:26
|
|
|
A bit wide
Hello Jan
Well, your kit seems to have grown a bit, or you didn't get the closests of fits, matching the wheelarch extenders to the standard body.
Last time I did this the RSR was not wider than 82,5.
Since the Porsche is quite high (49 mm) I say that the TC would let you run it in class 3 (with max 78 mm spur)
|
|
|
|
|
VaCooL
Posts: 18
Registered: 20-6-2003
Member Is Offline
Mood: Porsche 911 GT1 '96
|
|
posted on 11-5-2005 at 05:03
|
|
|
Hi Tamar
Thanks for the reply 
If thats correct I got a serius problem for the rear mudguard is so close to the boddy it can be.
I have attach some pictures of the car, so you can see it.
If the car shall drive in class 3 that will mean I should sand the mudguards down or?
Regards Jan
|
|
|
|
|
