Topic PostsLMS-forum
 

Not logged in


Recover Lost Password | Register     

      Printable Version | Subscribe | Add to Favourites

     Tech tips: Inlopen elektromotoren! 		  Post new thread Poll:  
willem
LMSadmin




Posts: 356
Registered: 5-11-1985
Location: Netherlands
Member Is Offline
Mood: Tired
posted on 14-3-2005 at 09:53 Reply With Quote
Inlopen elektromotoren!

http://members.lycos.nl/franshop/tip24.htm



View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
2h





Posts: 147
Registered: 19-11-2003
Location: Frederikssund, Denmark
Member Is Offline
Mood: Just looking for a fat lady...
posted on 14-3-2005 at 10:23 Reply With Quote


Does this mean that a Bison motor should run for 18-20V i 3 minutes in the first bucket of water, then first 1 minute in the other, then rest 1 minute, then run 1 minute again. The altasista translatie van Nederland to English is not the world best :)

Off to buy some distilled water.....:car:



Best regards
Henrik
View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
willem
LMSadmin




Posts: 356
Registered: 5-11-1985
Location: Netherlands
Member Is Offline
Mood: Tired
posted on 14-3-2005 at 11:26 Reply With Quote
Hold your horses!!

As this article was written for far more biger engines then the bison I reckon you need to adjust the values a bit.
First recommendation:
2 minutes on 3 volts frontwards and backwards
1 minute in a new clean cup frontwards and backwards.

I already blew one engine away for Moers. Had to use Tamar's group c engine:):):)

Experience will tell in the end:):):):)



View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
Post new thread Poll:

  » Tech tips » Inlopen elektromotoren! Go To Top