Rolf
Posts: 90
Registered: 5-1-2007
Location: Oslo, Norway
Member Is Offline
Mood: Not Set
|
|
posted on 8-7-2008 at 08:31
|
|
|
Question on part H5
It’s stated in F430 rules that a lexan motor is allowed (§6.6.g). At the same time it’s also stated that part H5 (§ 6.6.b is to be used) this
part does not fit in the right way on a lexan motor interior. In the original Fujimi set the H5 part is placed under part D3. Since the lexan motor is
made in one piece it’s therefore not possible to fit it right. The only way to get it in the motor is upside down and that looks quite silly.
Any suggestions if I should just glue it in there, upside down, or skip the whole part is much appreciated :-)
Rolf
I'll sleep when I'm dead
|
|
|
|
Big Al
Posts: 221
Registered: 4-6-2004
Member Is Offline
Mood: No Mood
|
|
posted on 8-7-2008 at 09:40
|
|
|
Rolf, cut it so you can put it in the right place, on each side of the Covers, and trim the cross member you cut, so that it can be glued inbetween
the engine covers, it will look perfect like that. While the rulebook says no part may be modified in anyway, this item HAS to be cut in order to fit
the Lexan Interiors..
Regards
Big Al
|
|
|
|
|
fola
Posts: 338
Registered: 8-10-2006
Location: The PLANET Earth.
Member Is Offline
Mood: ADMIN wanna be I D A M N right I'm building again & Sleepless in the celler
|
|
posted on 8-7-2008 at 16:32
|
|
|
Fits perfect with a little surgery....
|
|
|
|
|
Big Al
Posts: 221
Registered: 4-6-2004
Member Is Offline
Mood: No Mood
|
|
posted on 8-7-2008 at 19:33
|
|
|
Yup, thats how it should look when cut and mounted Rolf.
Nice engine Fola..
Al
|
|
|
|
|
Rolf
Posts: 90
Registered: 5-1-2007
Location: Oslo, Norway
Member Is Offline
Mood: Not Set
|
|
posted on 8-7-2008 at 22:42
|
|
|
I'm sorry to tel om not quite Fola yet... But it's in there  I did run
her the first 50+ laps at the Badet track this night. No track records but absolutely axeptable for a first spinn 
Rolf
I'll sleep when I'm dead
|
|
|
|
|
