Post Reply
Who Can Post?
All users can post new topics and all users can reply.
Username
Need to register?
Password:
Forgot password?
Subject:
(optional)
Icon:
Formatting Mode:
Normal
Advanced
Help
Andale Mono
Arial
Arial Black
Book Antiqua
Century Gothic
Comic Sans MS
Courier New
Georgia
Impact
Tahoma
Times New Roman
Trebuchet MS
Script MT Bold
Stencil
Verdana
Lucida Console
-2
-1
1
2
3
4
5
6
White
Black
Red
Yellow
Pink
Green
Orange
Purple
Blue
Beige
Brown
Teal
Navy
Maroon
LimeGreen
Message:
HTML is On
Smilies are On
BB Code
is On
[img] Code is On
[quote][i]Originally posted by marco[/i] [quote][i]Originally posted by tamar[/i] p.s. I just talked to Jean Marie and he will check the forum and will answer questions concerning the worlds via this forum. [/quote] [b]Thanks Tamar. Thanks in advance Jean Marie.[/b] [b]QUESTION 1 -- FERRARI F430 TECH RULES -- FRONT WHEELS[/b] [quote][i]6.5(b) WHEELS - Front rims must be aluminium min 21mm Ø outside, 20mm Ø inside. Front wheels are always at least 5 mm wide and minimum 25.5mm high. Rear wheels are handout Scaleauto wheels 27,5mm Ø 13 mm wide, 20mm Ø inside. Tyres are black.[/i][/quote] [b]1A.[/b] If the front wheels are ground to a 3 degree taper, where is the minimum tire diameter measured . . . on the inside of the wheel where the OD is smallest . . . or on the outside of the wheel where the OD is largest? [b]1B.[/b] Do the front wheels have to contact the tech block? [b]1C.[/b] Where is the width of the front spur measured . . . at the axle . . . or where the tire contacts the tech block? [b]1D.[/b] Are the front wheels to be at least 5mm wide . . . or are the front wheels to be at least 8mm wide with a minimum of 5mm in contact with the tech block? [b]Mark Campbell[/b] . [/quote]
Disable Smilies?
Use signature?
Turn BBCode off?
Receive email on reply?
Attachment:
Topic Review
This is a long topic, click
here
to review it.
»
The (unofficial) IMCA forum
»
FERRARI F430 TECH RULES -- FRONT WHEELS
» Reply